Feather Flags
Feather Flags
Our Feather Flags are premium quality, produced on 3oz polyester and printed using superior dye sublimation equipment for the longest lasting color available. Ideal for advertising businesses, events and trade shows. Available with indoor or outdoor hardware. Flags can be folded, stored and assembled with ease. Printed single or Double Sided. The Double Sided product consists of two 3oz polyester flags sewn together with a Block Out Layer in the middle. This will allow you to upload an image on both sides and avoid transparency on the flag. All double-sided flags will come with the black sleeve as a standard option
| 24″ x 81″ (8 ft) | 32″ x 123″ (12 ft Regular) | 32″ x 99″ (10 ft) | 36″ x 123″ (12 ft Jumbo) | 37″ x 161″ (15 ft) |
| $ | $ | $ | $ | $ |
File Preparation:
Resolution: 300dpi Color Mode: CMYK
Bleed: 0.125” (0.625 on each side) File Types: PDF (recommended)
Design Guidelines
Bleed must extend past the cut-line and will be trimmed from the product during the final cutting phase. When the image is required to extend all the way to the edge, bleed is needed to preserve the finished look and the quality of the final product.
- Please keep all text at least 0.125″ inside the cut-line, the doted line.
- The final cut-line is the black boarder, 3.5″x2″.
- The bleed for Standard Products is 0.125″., the pink bolder, .
- When using a blue in your design, always make sure to leave at least a 30% difference in your Cyan and Magenta .
- Blue is close to purple in the CMYK spectrum. Remember, use a low amount of magenta whenever using high amounts of cyan to avoid purple. Example: C-100 M-70 Y-0 k-0
- We recommend using C 60 M 40 Y 40 K 100. This will give you a deep, dark, rich black.
- We prefer that you send PDF with embedded or outlined fonts.
- For best result, we recommend 300 DPI or higher.
- For fine lines and text smaller than 9pt, use black (100% K) only.
